The Analog Input Module can receive 0-10V or 4-20mA signals. There are eight inputs per module. This page shows how to install and wire the IG41 AI Module.
Important: Remove the power before installing or removing modules, they cannot be hot swapped!
LED Light Guide
Learn what all of the lights mean and what to do here: IG41 LED Guide
Note for Installations using Analog or Digital IO Modules:
The gateway may need to update before it will work with the IO modules. If the gateway is powered on for the first time with the modules connected and the main LED turns red, this is the case. Power down the device, remove the modules, and power it on again. Let it stay powered on and connected with a green LED for 30 minutes, then try adding the modules on again after removing power. If this does not work, contact support.
Wiring Diagram
Install Tips
The IG41 AI Module accepts 0-10V and 4-20mA inputs
